Test Code

CPT Codes

Preferred Specimen
0.5 mL serum collected in a red-top tube (no gel)

Minimum Volume
0.25 mL

Collect specimen in a non-additive red top tube. Spin down immediately and pour off into a 13 x 75 mm plastic transport tube.

Transport Container
Transport tube

Transport Temperature

Specimen Stability
Room temperature: 7 days
Refrigerated: 7 days
Frozen: 28 days

Reject Criteria (Eg, hemolysis? Lipemia? Thaw/Other?)
Gross hemolysis • Moderate hemolysis • Grossly lipemic • Grossly icteric • Serum separator tube

Liquid Chromatography/Tandem Mass Spectrometry (LC/MS/MS)

FDA Status
This test was developed and its analytical performance characteristics have been determined by Quest Diagnostics. It has not been cleared or approved by the U.S. Food and Drug Administration. This assay has been validated pursuant to the CLIA regulations and is used for clinical purposes.

Setup Schedule
Set up: Mon, Wed; Report available: 10 days

Reference Range
See Laboratory Report

Clinical Significance
Primary aldosteronism should be suspected whenever a patient has the triad of hypertension, hypokalemia, and inappropriate renal potassium wasting. The biggest challenge is the differential diagnosis between the more common adrenal adenoma and bilateral hyperplasia. Because adrenal adenomas increase the circulating levels of 18-hydroxycorticosterone (18-OH B), serum levels of 18-OH B may be useful to differentiate them from bilateral adrenal hyperplasia. The cutoff point appears to be about 50 ng/dL of serum. Most values are around 100 ng/dL. The higher the level of this precursor, the greater the possibility that an adrenal adenoma is present. J Clin Endocrinol Metab. 97: 881-9, 2012.

Performing Laboratory
Quest Diagnostics Nichols Institute-San Juan Capistrano, CA
33608 Ortega Highway
San Juan Capistrano, CA 92675-2042

The CPT Codes provided in this document are based on AMA guidelines and are for informational purposes only. CPT coding is the sole responsibility of the billing party. Please direct any questions regarding coding to the payor being billed. Any Profile/panel component may be ordered separately. Reflex tests are performed at an additional charge.