Mumps Ab, IgG

Test Code
MUMPG


CPT Codes
86735

Preferred Specimen
GOLD (SST)


Other Acceptable Specimens
Red
Only Serum is acceptable


Instructions
  • Collect 1 gold topped, serum separator tube.  No anticoagulants or preservatives should be added.
  • Allow tubes to clot adequately before centrifugation.
  • Avoid using hemolyzed, lipemic, or bacterially contaminated sera.


Specimen Stability
  • Eight (8) hours at room temperature.
  • Forty eight (48) hours at refrigerator temperature 2° and 8°C degrees.
  • If delay in testing is beyond 48 hours, store test sera at -20°C or lower. Avoid multiple freeze/thaw cycles that may cause loss of antibody activity and give erroneous results.


Reference Range
Index Value for Mumps Ab, IgG:      
 
  • Negative:   0.89 IV or less:  Indicates no detectable IgG antibodies to mumps virus.  No current or previous infection with Mumps. Patient is presumed to be non-immune and are therefore susceptible to a primary infection.
  • Equivocal:    0.90 - 1.09 IV:    Specimens with OD ratio values in the equivocal range should be re-tested in a few weeks or by an alternate serologic method.
  • Positive:   Greater 1.10 IV:  Indicates a past or current infection with Mumps and that the patient should be considered immune to Mumps primary infection.
 
The results of this test system are qualitative. The magnitude of the ratio for positive specimens may not correlate with antibody titer. If testing a particular sample occurs early during primary infection, no detectable IgG may be evident. If Mumps infection is suspected, a second sample should be taken at least fourteen days later.


Clinical Significance
When performed according to these instructions, the results of this test, together with other clinical information, may aid in the determination of immune status, and/or aid in the diagnosis of Mumps infections.


Performing Laboratory
CRMC Microbiology/Immunology Laboratory



The CPT Codes provided in this document are based on AMA guidelines and are for informational purposes only. CPT coding is the sole responsibility of the billing party. Please direct any questions regarding coding to the payor being billed. Any Profile/panel component may be ordered separately. Reflex tests are performed at an additional charge.